AC ANTTYA relay install
Warning
1. Usually the receiver and transmitter have been paired with each other in factory. If not, please reprogram them.
2. Reset before you want to change the operating mode.
3. After reset, all the remote controls cannot work anymore.
4. Replace the battery in time when the remote transmitter voltage is low. To get the stronger signal transmission.
5. Slightly stretch the antenna on the receiver for better signal reception.
6. The remote transmitter need to have 2 or more buttons, if you want to set up in latched mode.
Operating Mode
Momentary Mode:
1. Press and hold one button, relay will turn on;
2. Release the button, this relay will turn off.
How to program
1. Press the learning button(on the receiver) 1 times.
Wait for 3 seconds;
2. Press one button on the remote control. Succeed
Toggle Mode:
1. Press button "A", relay will turn on;
2. Press button "A" again, this relay will turn off.
How to program
1. Press the learning button(on the receiver) 2 times.
Wait for 3 seconds;
2. Press one button on the remote control. Succeed.
Latched mode:
1. Press button "A", relay will turn on;
2. Press button "B", this relay will turn off.
How to program
1. Press the learning button(on the receiver) 3 times.
Wait for 3 seconds;
2. Press button "A" on the remote control.
Wait for 3 seconds;
3. Press button "B" on the remote control. Succeed.
Delay 5 / 10 / 15 seconds mode:
1. Press button "A", relay will turn on;
2. After 5 / 10 / 15 / seconds, this relay will turn off automatic.
How to program
1. Press the learning button(on the receiver) 4 / 5 / 6 (delay 5 / 10 / 15 seconds mode) times.
Wait for 3 seconds;
2. Press button "A" on the remote control. Succeed.
Reset:
Press the learning button (on the receiver) 8 times. succeed.
Troubleshooting
If the receiver and transmitter cannot operate normally, try to solve the problem by follow the step below.
1. Please check if batteries power is used up. The indicator LED on remote transmitter does not light up or is dimly lit.
2. Please check if your receiver is wired correctly. It is important to make sure the wiring is correct.
3. Please check if there are any transmitters operating in the surrounding environment, as they may interfere with pairing.
4. Reprogram the receiver and transmitter. Usually this can solve a lot of problem.
5. If the problem still remains, please contact us in time. We will do our best to solve your problem.