Smart Light Switch Wireless RF 433Mhz
24 Feb 2025
0 Comments
Warning
1. Usually the receiver and transmitter have been paired with each other in factory. If not, please reprogram them.
2. Reset before you want to change the operating mode.
3. After reset, all the remote controls cannot work anymore.
4. Replace the battery in time when the remote transmitter voltage is low. To get the stronger signal transmission.
5. Slightly stretch the antenna on the receiver for better signal reception.
6. The remote transmitter need to have 2 or more buttons, if you want to set up in latched mode.
7. Usually, we control lights using toggle mode
Operating Mode
Toggle Mode:
1. Press button "A", relay will turn on;
2. Press button "A" again, this relay will turn off.
How to program
1. Press the learning button (on the receiver) 2 times. The indicator LED on the receiver will light up;
2. Press one button on the remote transmitter, The indicator LED on the receiver will flashing several times and then light down. Succeed
Reset
Press the learning button (on the receiver) 8 times. The indicator LED on the receiver will flashing several times and then light down. succeed.
